Raise your two assemblies upright from Step 1. Insert one #3 pole into one #7
straight connector, align the Velcro to be facing the same direction, and tighten the
necessary screws (#20) with hex key (#19). Add another #3 pole to the other side of
the connector and repeat. Insert horizontal tube you just assembled into the #9 and
#10 connectors, aligning the Velcro so it’s facing down. Tighten the screws (#20) on
#9 and #10 connectors with the hex key (#19). Build another horizontal length of
tube for the other side of the bed.
2
3
7
9
10
Push Poles all the
way into connectors
Connector
rests above bolt
7
To Next Page
Loading...
