Cuddeback CuddeLink - Set up the REMOTE Camera

9

SetCL LOCto001.ThisisaLocaonIDnumberusedto
idenfyeachcamera.WerecommendHOMEalwaysbe
setto001.
SkipoverCL INFObypressingMORE
PressUPtosetCLLOCto001
SetCL CHANtoanynumber.Youcanleavethisat1but
werecommendyouchangethis.Pickanychannel,but
rememberwhatyouselectedasallcamerasmustbeset
tothesamechannel.
SetCLCHANtoanynumber
Thatisallyouneedtodo.TheHOMEcameraisnow
setupproperly.DeployandARMtheHomecamera
(PressMODEunlARMisselected).
Note—theHomecameramust bearmedfortheCuddeLinknetwork
tofuncon.
10

Set up the REMOTE camera
Setthenormalcameraparametersasexplainedinthe
camera’smanual.Date,me,cameradelays,etc.
SetCL MODEtoREMOTEthenpressMORE.
PressUPorDOWNto
selectHome
SetCL LOCto002.IMPORTANT–allcamerasshould
haveauniqueCLLOC(locaon)number.We
recommendyousetHometo1andsetremotesas2,3,4
andsoon.
PressUPtosetCLLOCto
002
SetCL CHANtothesamechannelyousetontheHOME
camera.IMPORTANT–allcamerasmustbesettothe
samechannel.
SetCLCHANtosame
channelasHOME
LeaveCL DELAYandCL COUNTinthedefaultsengsof
CLDELAY5andCLCOUNT250.
Leavethesesetto
defaults