• There are four sets of pre-installed
screws with washers on the side of the
grill body. Remove these and use them
to attach the side shelf to the Grill Body
through the same holes.
• NOTE: Do not accidentally remove the
two screws that were installed earlier to
secure the Grease Channel.
• Remove the pre installed screws from the Handle (25).
• Attach the handle to the lid with the screws coming out
from the inside of the lid going through first the Handle
Bezel (23) then the Insulating Washer (24) and finally
threading into the Handle (25).
12
ASSEMBLY INSTRUCTIONS
STEP 9 - SIDE SHELF
-----------------------------------------------------------------------------------
STEP 10 - HANDLE
-----------------------------------------------------------------------------------
To Next Page
Loading...
