4 5
PARTS
1. Housing
2. ON/OFF Switch
3. Kettle
4. Kettle Handle
5. Internal Kettle Plug
6. Kettle Lid
7. Kettle Lid Handle
8. Kettle Stirrer
9. Door (removable)
10. Tilt Door (removable)
11. Unpopped Kernel
Catcher & Screen
12. Kettle Release Tab
13. Kettle Hook
14. Accessories
– Oil Measuring Spoon –
1 tbsp.(15 ml)
– Kernel Measuring Cup –
¼ cup (60 ml)
– Popcorn Scoop
15. Main Power Cord (not shown
)
ASSEMBLY
PROCEDURE
1. Run the kettle stirrer
through the opening in
the center of the kettle lid.
Insert the top of the kettle
stirrer into the top of the
main housing and turn
counterclockwise to secure
in place.
2. Place the kettle onto the
kettle hook on the left side
of the main housing. Raise
the kettle so that it rests on
the top of the kettle release
tab.
BEFORE FIRST USE
Make sure the popcorn maker
is unplugged before you perform
the following:
1. Check to be sure the voltage
(120V – 60 Hz) is suitable to
your home.
2. Clean the internal surface of
the kettle with warm soapy
water; rinse well and dry with
a clean cloth. Wipe down inner
and outer housing with a damp
cloth. Be sure that all parts
are completely dry before
assembly.
9
10
11
12
13
2
1
14
8
4
6
7
3
5
To Next Page
Loading...
