What to do if my Current Audio AMP-870 Amplifier has no audio from speakers?
If your Current Audio Amplifier is not producing any audio from the speakers, check the speaker wiring at both the amplifier and the speakers to ensure a proper connection.
How to fix no audio from one channel or one zone only on Current Audio Amplifier?
If you're experiencing a lack of audio from only one channel or zone on your Current Audio Amplifier: * Check the front LED above the zone. If it's RED, there might be a short or a bad speaker. Measure the ohms of the wire with the speaker unplugged; it should read about 6.5 ohms for an 8-ohm speaker. Correct the issue by replacing the wire and/or speaker. If you're using a manual volume control, inspect the connections and plug locations. Try switching the speaker plug with a zone that is working. * Make sure that the rear zone level adjustment is not turned down. Increase the level clockwise until you reach an adequate level. * Check the audio cable connections and replace the cable to see if that fixes the problem. Also, make sure that the cable is connected to the proper inputs....
Provides essential safety and operating guidelines for the amplifier.
Explains safety symbols and provides crucial warnings for safe operation.
Lists the items included with the amplifier package.
Details the technical performance parameters of the amplifier.
Defines key terms used in the amplifier manual for user understanding.
Highlights the main functional capabilities and design elements of the amplifier.
Identifies and explains the function of each connector and control on the rear panel.
Guidance on optimal placement for ventilation and safe operation of the amplifier.
Instructions for making audio and power connections, focusing on input connectivity.
Detailed instructions for connecting speaker wires to the amplifier outputs.
How to choose between global and individual inputs for each zone.
Instructions for bridging two channels for increased power output.
Explains the three methods for powering the amplifier on.
Illustrates how to connect the amplifier for multi-room audio distribution.
Diagrams and instructions for multi-room hookup using an audio matrix switcher.
Addresses problems like no sound, hum, or buzz with possible causes and solutions.
Troubleshoots 12V trigger not working and improper speaker connections.
Guidance on global level settings, zone additions, and bridged stereo configurations.
Details on 12VDC trigger operation and using surge protectors like the ILS120.
Outlines the terms, conditions, and limitations of the product's warranty.
General| Brand | Current Audio |
|---|---|
| Model | AMP-870 |
| Category | Amplifier |
| Language | English |
To Next Page
