28
It is advisable to leave the door closed until you are ready to unload the crockery. However, leaving
the dishwasher door ajar which will speed up the drying process.
At the End of a Programme
At the end of the programme, the end of cycle indicator will turn on.
Setting a Timer Delay
You can set a delay timer on your dishwasher, this will start the wash programme 3, 6 or 9 hours after
setting the timer.
1. After selecting your desired programme, press the
DELAY TIMER button, press once for a 3 hour
delay, twice for a 6 hour delay and three times for a 9 hour delay. If you continue pressing the button
the delay will switch off.
2. Press the START/PAUSE button to start the programme the delay LED will flash once to indicate the
programme has started, and in 3, 6 or 9 hours the dishwasher will start.
Selecting Half Load Mode
Your dishwasher has a half load setting for when you haven’t filled your dishwasher and you just want to
wash a few items. The half load mode isn’t available on programmes 1 and 2. This will still wash the top and
bottom basket, it will reduce the programme time and in some cases it will reduce the water used.
1. Select your desired programme then press and hold the
// button for 3 seconds the LED will light on
the button to show half load is selected.
2. Press START/PAUSE to start the programme.
Cancelling Half Load Mode
If you don’t cancel the half load mode it will remain on next time you select a programme.
• Press and hold the
// button for 3 seconds, when the LED on the button switches off the mode is off,
or press the ON/OFF button.
Currys Essentials Freestanding Dishwasher CDW45W18 Manual.indd 28 28/03/2018 16:10
To Next Page
Loading...