CURTMFG.COM
•
NEED ASSISTANCE?
•
877.287.8 634
•
60639-INS-RA
•
PAGE 2
Anchor Installation
Insert both safety chain anchors (#1) into the
rear-most truck bed puck system mounts.
Note: Always install in the rear-most mounts.
Once inserted, rotate the anchors 90°
toward the taillights of the truck.
Insert a 10mm pin (#2) into the top of each
safety chain anchor and secure using the
provided 5mm lynch pins (#3).
Note: The 10mm pins and 5mm lynch pins
must be fully inserted and engaged.
When the safety chain anchors are not
in use, remove them from the truck bed
mounts and store in a dry, clean area.
2
3
1
Rear-most puck system
mount (both sides)
Both rings should
face the taillights
of the truck
Ball Installation
To install the gooseneck ball, lift the handle
on top of the ball from its seat and rotate 90°.
Insert the gooseneck ball into the truck
bed puck system receiver tube. Rotate the
lift handle to the locked position and flip
it down into its seat.
If the lift handle does not freely rotate into the
locked position, rotate the ball while applying
light pressure to the side of the lift handle.
When the lift handle rotates into the locked
position, flip it down into the seated position.
When the gooseneck ball is not in use,
remove it from the receiver tube and
store in a case or a dry, clean area.
Place a rubber cover into the gooseneck
receiver when the ball is removed to
keep dirt and debris out.
Handle must match the ball profile while
in the locked position, prior to coupling
Truck bed
Puck system
receiver tube
Locked ball
Unlocked
lift handle
Seat
To install,
rotate
handle 90°
To Next Page
Loading...
