2. Hold the mounting bracket in the position selected and mark the hole
locations through the bracket.
3. Using a 1/8" diameter bit, drill holes in the marked locations.
4. With a screwdriver or a 1/4" nut driver, secure the bracket in place using
(2) self threading screws (provided). Do not over-tighten.
5. Mount the brake control unit in the bracket using (4) screws.
Wiring
Disconnect the tow vehicle’s negative battery terminal from its battery
post before beginning the wiring process.
Tow vehicles equipped with a factory brake control plug:
Most late model pickups and utility vehicles are equipped with a plug that
allows quick brake control installation. Check the owner’s manual for plug avail-
ability, location and installation.
If the mating plug supplied with the vehicle is no longer available, a CURT quick
plug can be used (see CURT catalog for application information).
Tow vehicles not equipped with a factory brake control plug:
Suggested: CURT part number 51500 brake control wiring kit.
Mount a 30 amp, auto reset, circuit breaker as close to the battery as possible.
IMPORTANT: When passing wire through sheet metal, always go through an
existing grommet, add a grommet, or use silicone sealer to protect the wire from
sharp edges.
To Next Page
Loading...