This package includes:
(1) Brake control module with quick plug
(1) Mounting bracket
(6) Screws
(1) Quick setup reference card
One or more of the following will also be needed to complete installation
- Brake control connection harness supplied with the tow vehicle (if equip’d)
- CURT quick plug – custom connector for specic vehicles.
See catalog for availability
- CURT part number 51515 or 51516 male quick plug with pigtails
- CURT part number 51500 brake control wiring kit
Important Information
- CAUTION: Read and follow installation and setup instructions carefully.
Failure to do so could result in damage to the brake control unit, no trailer
brakes or poor brake performance.
- CAUTION: Disconnect the electrical plug between the trailer and tow
vehicle before testing a breakaway switch. Failure to disconnect may
damage the brake control unit.
- CAUTION: Avoid mounting the brake control module near a CB radio or other
RF transmitter.
- WARNING: The brake control unit must be mounted rmly in place.
Failure to do so could lead to improper operation and/or brake failure.
- WARNING: The brake control unit’s positive (with 30 amp circuit breaker)
and ground wires must be connected directly to the tow vehicle’s battery
To Next Page
Loading...