Curtis Cafe Primo Cappuccino - Adjusting Product Ratio

PROGRAMMING GUIDE PG14
$"'&1$130(3"..*/((6*%&ø /$
Product % Ratio
1 This function sets the ratio of product powder dispensed. The higher the powder ratio, the richer the product
dispensed. The range is from 10% to 100% (7 grams per 10%). The powder ratio for each button is set
independent of the others.
2 Make sure the rear toggle switch is in the ON position and the ready light(s) are on.
3 Press and hold the STOP/WASH button (for about 10 seconds) until all
the lights start blinking, then release.
4 Press and hold the desired PUSH button for approximately one second,
then release.
5 The current setting will be indicated by the number of times the light
nBTIFTTFQBSBUFECZBQBVTF4FF5"#-&
6 To exit without changing the powder ratio, press one of the other PUSH
buttons.
7 To change the product throw, press and hold the desired PUSH button
BHBJO 3FBE UIF OVNCFS PG nBTIFT PO UIF MJHIU BOE SFMFBTF XIFO UIF
OVNCFSPGnBTIFTDPSSFTQPOETUPUIFEFTJSFETFUUJOH
8 Press any other PUSH button to set and exit.
# of Flashes Ratio
1 10% (7 gm)
2 20% (14 gm)
3 30% (21 gm)
4 40% (28 gm)
5 50% (35 gm)
6 60% (42 gm)
7 70% (49 gm)
8 80% (56 gm)
9 90% (63 gm)
10 100% (70 gm)
TABLE 2