Curtis Cafe Primo Cappuccino - Setting Preset Dispense Mode; Resetting to Manual Dispense Mode

PROGRAMMING GUIDE PG14
Preset Dispense Mode
Preset dispense sets the buttons to dispense the amount of product by time rather than holding the button until the
desired amount is dispensed (manual dispense mode). The dispense buttons are set to manual dispense mode
at the factory. After being changed to preset dispense, the buttons may be reset to manual dispense according to
the section below. To set a button to preset dispense mode:
1 Make sure the rear toggle switch is in the ON position and the ready light(s) are on.
2 Press and hold the STOP/WASH button (for about 10 seconds) until all the lights start blinking, then release.
3 1SFTTBOEIPMEUIF164)CVUUPOUPQSFTFUVOUJMUIFMJRVJECFHJOTUPnPXUIFOSFMFBTF1SFTFUUJNJOHTUBSUTXIFO
MJRVJECFHJOTUPnPX
4 8IFOUIFDVQJTmMMFEUPWPMVNFQSFTTUIF164)CVUUPOPODFBHBJOUPTUPQEJTQFOTJOH5IFQSFTFUWPMVNF
for the button has now been set.
5 3FQFBUUIFBCPWFQSPDFTTGPSBOZPUIFSCVUUPOTZPVXJTIUPTFUUPQSFTFUEJTQFOTF
Manual Dispense Mode
Resets a button set to preset dispense mode, back to manual dispense.
1 Make sure the rear toggle switch is in the ON position and the ready light(s) are on.
2 Press and hold the STOP/WASH button (for about 10 seconds) until all the lights start blinking, then release.
3 Press and holdUIF164)CVUUPOUPCFTFUCBDLUPNBOVBMEJTQFOTFNPEF)PUMJRVJEXJMMTUBSUUPnPXContinue
UPIPMEEPXOUIF164)CVUUPOVOUJMMJRVJETUPQTnPXJOHUIFOSFMFBTF. The button has now been reset to
manual dispense mode.
4 3FQFBUUIFBCPWFQSPDFTTGPSBOZPUIFSCVUUPOTZPVXJTIUPSFTFUUPNBOVBMEJTQFOTFNPEF
continued...
$"'&1$130(3"..*/((6*%&ø /$
WARNING:5IFTFTUFQTJOWPMWFXPSLJOHXJUIIPUXBUFS"WPJETQMBTIJOHBOETQJMMJOH
WARNING:5IFTFTUFQTJOWPMWFXPSLJOHXJUIIPUXBUFS"WPJETQMBTIJOHBOETQJMMJOH
Control panel design varies based on model