Curtis CBHT - Quick Start and UCM Programming; Universal Control Module (UCM) Programming

4
Your Curtis G3/Gold Cup Series is factory preset for optimum performance.
After connection to water and power; the rear toggle switch must be on. You will hear a beep sound, indicating power is available to the controller.
The control displays . Press ON/OFF button and the screen will display . After three seconds, is displayed.
Waterwillllthetank(approximately2-3minutesdependingonwaterowrate).Whentheproperlevelisreached willappearonthescreen.It
takes approximately 20 minutes to reach the set point temperature.
Control will display when temperature reaches the set point. The unit is now ready to brew.
<CBHVT>
CURTIS
CURTIS
CURTIS
Ready to Brew
CURTIS
Filling
CURTIS
Heating
Program Menus
From Program Menus press ►. The display will show the next feature Coffee Recipes.
Coffee Recipes (factory set to Gourmet STD)
Press  to select. If selected, press ◄ or ► to choose a coffee recipe: Gourmet STD, Light Roast, Dark Roast, High Yield,
Filter Pack or Decaf. Press  to select the desired recipe.
Non-Brew Program
Press  to select ◄ or ► to pass by these options and continue to the next group. The selections for Non-Brew Program
are listed below.
Temperature (factory set to 204ºF)
Press  to select. Then press ◄ or ► to move to the desired temperature, then  to set and exit. The temperature is
programmablefrom170ºFto208ºFin2-degreeincrements.
Energy Save Mode (factory set to OFF)
Press  to select. Then press ◄ or ►tochooseON,OFForON140ºF,then to set and exit. When ON, the brewer will
automatically shut off 4 hours after the last brew. When the feature is OFF, the brewer does not utilize the energy saving mode.
IntheON140ºFposition,thetemperaturelowersto140ºF,iftheunithasnotbrewedin4hours.Thisfeaturewillsaveenergyby
maintaining a lower temperature in the tank in periods of non-operation.
Brew Count Odom
Press  to display total brew cycles. Press EX or Reset.
Brew Count Total
Press  to select. This feature shows the total gallons and total brew cycles on the brewer. It cannot be reset.
Temperature
Energy Save Mode
Brew Count Odom
Coffee Recipes
Non-Brew Program
Brew Count Total
Programming the Universal Control Module (UCM)
Turn off the control panel by pressing the ON/OFF button. Press and hold the bottom/right coffee brew button (#4 in illustration) and then press and release the ON/OFF button.
Continue holding the bottom-right brew button. The screen will display , wait until is displayed. Enter the 4-digit access code, the code corresponds to
thebuttonsillustratedbelow.Thedefaultcodesetatthefactoryis1-2-3-4.
After the 4-digit code is entered, will be displayed. You can now enter the program menu features.
Enter Code
– – – –
Program Menus
< Select >
Entering
Programming Mode
PROGRAM MENUS COMBO BREWER
431 2
◄ Scroll left (button 1)

Select or Enter to save new parameter (button 2)
► Scroll right (button 3)
All programming selections are performed with the
three center buttons. The symbols above and below the
buttons are: