Curtis G3 - Page 33

33
User manual Curtis G3 Tea/Coffee Combo brewer
Software | Control module
Access Code - sets the access code entered to access
programming mode (the factory default is 1-2-3-4).
Once accessed (
) press or to select the number
to be changed. Press
repeatedly to change the
number value. Press
or ,to select the next number
to change. When done, press
until ex fl ashes on the
display and press
.
Press
to display the subsequent menu features.
Banner Name - changes the banner name that
appears on the display. No banner name appears when
all blanks are entered. Once accessed (
), press or
to select the letter to change. Press repeatedly to
change the letter. When done, press
or until ex
fl ashes on the display and press
. Press to display
the subsequent menu features.
P-Maintenance - adjusts the P-Maintenance
(preventive maintenance) brew monitor. When on, the
UCM measures the number of gallons brewed before
the P-Maintenance reminder appears on the display.
The range is Off to 11000 L. Once accessed (
),
press
or to select the desired setting, then press
to save. Press to display the subsequent menu
features.
Beeper On/Off - turns the beeper that is heard each
time a button is pressed. Once accessed (
), press
or to toggle between On and Off. Press to save.
Press
to display the subsequent menu features.
Quality timer - notifi es the user that the coffee/tea
is no longer fresh by monitoring the amount of time
since the BREW button was last pressed. When time
expires, an audio alarm turns on and Quality Timer
fl ashes on the display. Once accessed (
), press or
to increase or decrease the amount of time. The
range is Off to 10 hours. Press
to save. Press to
display the subsequent menu features.