Curtis G3 User Manual

40
User manual Curtis G3 Tea/Coffee Combo brewer
Care | Daily cleaning
5.3.3 Cleaning the Tea Dispenser
Cleaning the Container
 Prepare a mild solution from 30 g special cleaning
powder (see accessories) and 2 L warm water.
Remove the dispenser from the brewer and remove
the lid. Rinse.
 Wash - Wipe the exterior surfaces with a sponge
and the detergent solution to remove spills and
debris. Use the detergent solution and a soft bristled
brush to wash the inside of the container.
 Rinse - Rinse with clean, warm water
 Sanitize* - Sanitize the interior of the dispenser
using a commercial sanitizer suitable for food grade
applications. Sanitize according to the directions on
the package.
* If a three compartment sink large enough to
submerge the dispenser is not available, swab, brush
or pressure spray the sanitizing solution according
to the directions on the package.
 Air Dry - Turn the container upside down and allow
to air dry.
Cleaning the Faucet Parts, Lid and Drip Tray

Disassemble the faucet - Unscrew the faucet
assembly from the dispenser. Then, unscrew the
handle/bonnet assembly from the top of the faucet
and remove. Inspect the seat cup for wear. Replace
the seat cup if it is damaged.
 Wash - Wash the lid, drip tray and faucet parts with
the detergent solution.
 Rinse - Thoroughly rinse all parts with clean, warm
water.
 Sanitize - After rinsing, place the faucet parts
in the sink to be sanitized. Immerse them in a
commercial sanitizer suitable for food grade
applications. Sanitize according to the directions on
the package
 Air Dry - Allow all parts to thoroughly air dry.
Follow the accessories chapter,
customer care programm
page 59

Curtis G3 Specifications

General

Brand	Curtis
Model	G3
Category	Brewing Systems
Language	English