56
MAINTENANCE
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
Owner’s Guide
6. Turn fuel shut-off valve to closed (OFF) position.
7. In a properly ventilated area, run engine until remaining
fuel in carburetor and fuel lines is depleted and the engine
stalls.
8. Return neutral lock to OPERATE position.
9. Loosen (do not remove) the carburetor drain screw. Allow
any remaining fuel to drain into an approved container and
pour the fuel collected into the vehicle fuel tank.
10. Add Sea Foam (4 oz. for a full tank of fuel) to stabilize fuel
and install the tank cap securely.
11. Tighten carburetor drain screw.
12. Remove spark plug and pour approximately 1/2 oz. (15 ml) of SAE 10 - 30 weight oil or fogging oil into the cylinder.
13. Rotate the crankshaft by hand several times, then install the spark plug.
14. Do not engage the park brake, but secure the car from rolling.
15. Change oil while engine is still warm.
16. Clean body, chassis and engine of debris, mud, chaff or grass.
CAPACITIES AND REPLACEMENT PARTS
Fuel Shut-off
Valve
Turn to “OFF”
Position
Fuel Tank Capacity (Early
Production)
Fuel Tank Capacity (Late
Production)
Engine Oil
Oil Filter
Air Filter
Spark Plug
Starter/Generator Belt
Clutch Belt
Rear Axle Oil
Fuse
LED Bulb
Headlight Bulb
Turn Signal Bulb
5.2 gal (19.8 liters) / 87 Octane Min
1.4 US qt (1.3 liters)
51 oz (1.5 liters) / SAE 30
2 oz (60 mL) (P/N 625753)
15 amp (P/N 18392G1)
(P/N 619101)
(P/N 619100)
(P/N 619102)
P/N 607454
P/N 28463G01
NGK BPR2ES (P/N 607462)
.028” - .031" (.7 mm - .8 mm) Gap
P/N 26414G1
P/N 618630
#1157 (P/N 611242)
Taillight Bulb
Friction Modifier (Rear Axle)
6.0 gal (22.7 liters) / 87 Octane Min
To Next Page
Loading...
