CVW TX:7103 - Power Supply and Starting the Device; Transmitter Power Methods; Receiver Power Methods

DC
Power supply and start
The transmitter uses any of the following power supply methods,
long press the power button 3S to start the transmitter
a) Install the NP-F battery in the NP-F battery slot on the back of the
transmitter
1. The receiver uses any of the following methods to supply power. Press
and hold the power button 3S to start the receiver
2.
Use the included DC power adapter to power the product
a) D-type to DC cable is required to use V-bucket batteries
to power the product
D-type- DC
b) Use V button battery to power the product (need to use D-type to DC cable)
D-type-DC
09 10