CyberPower UT1500 - Technical Information and Support; LED Indicator Definitions; Troubleshooting Common Issues

TECHNICAL SPECIFICATIONS
DEFINITIONS FOR ILLUMINATED LED INDICATORS
LED
Alarm
Condition
On Off Normal
Flash Beep Twice Utility Failure - The UPS is providing battery power to outlets.
Flash Rapid Beeping
Utility Failure - The UPS is providing battery power. The rapid beeps indicate the battery will run out
of power shortly.
On/Flash Constant Tone
Overload - Occurs when connected equipment exceeds the rating of the unit. Turn the UPS off and
unplug at least one piece of equipment from the UPS.
TROUBLESHOOTING
Problem
Possible Cause
Solution
The UPS does not perform
expected runtime.
Batteries are not fully charged.
Recharge the battery by leaving the UPS plugged in.
Battery is slightly worn out.
Contact CyberPower Systems Technical Support.
The UPS will not turn on.
The unit is not connected to an AC outlet. The unit must be connected to a 220-240V outlet.
The battery is worn out.
Contact CyberPower Systems Technical Support.
Mechanical problem.
Contact CyberPower Systems Technical Support.
Outlets do not provide power to
equipment
Fuse is blown or breaker is tripped due to
overload.
Turn the UPS off and unplug at least one piece
connected equipment. Unplug the power cord of the
UPS then replace the blown fuse with a spare one or
press the circuit breaker knob. Connect power cord
then turn the UPS on. Make sure that your spare fuse
meets the specification.
Batteries are discharged Allow the unit to recharge for at least 4 hours.
Unit has been damaged by a surge or spike.
Contact CyberPower Systems Technical Support.
For more information, visit www.cyberpower.com
All rights reserved. Reproduction without permission is prohibited.
6F, No. 32, Sec. 1, Chenggong Rd., Nangang District, Taipei 115, Taiwan
Model
UT1500E UT1500EI UT1500E-AS UT1500E-IN UT2200E UT2200EI UT2200E-AS UT2200E-IN
Capacity (VA)
1500 2200
Watt (W)
900 1320
Input
Voltage Range
165~290Vac
Nominal Frequency
50 Hz
Output
On Battery Output
Voltage
Simulated Sine Wave at 230Vac +/-5%
On Battery Output
Frequency
50 Hz +/-1%
Overload Protection
Breaker / Fuse
Physical
Total # of UPS
Receptacles
4
SCHOKO
6 IEC 4 ASEAN 4 INDIA
4
SCHOKO
6 IEC 4 ASEAN 4 INDIA
Dimensions (W x H x
D)(mm)
148 X 178 X 298
Weight (kg)
9.1 kg 10.8 kg
Battery
Sealed Maintenance
Free Lead Acid Battery
RBP0089 x2 RBP0090 x2
Typical Recharge Time
8 Hours
Warning Diagnostics
Indicators Power On / Using Battery
Audible Alarms
On Battery, Low Battery, Overload, Fault
Surge Protection
Network/ Phone/ Fax/
Modem Protection
YES
Communication
PowerPanel® Personal
Edition Software
Windows 8/7/Vista/XP/2000,Server 2012/2008/2003, Linux
Environmental
Operating Temperature
0°C to 40°C
Operating Relative
Humidity
0 to 90%
Management
Auto-Charger
Yes
Auto-Restart
Yes