Safety
Page 1-3
Facility Safety Precautions
• Make sure all user and safety precautions are observed.
• Read and understand the Owner's Manual completely before using the unit.
• Make sure all users are properly trained on how to use the equipment.
• Make sure that each machine is setup and operated on a solid level surface. Do not install
equipment on an uneven surface.
• Perform regular maintenance checks on the equipment. Also pay close attention to all areas most
susceptible to wear, including (but not limited to) cables, pulleys, belts and grips.
• Immediately replace worn or damaged components. If unable to immediately replace worn or
damaged components then remove from service until the repair is made.
• Do not attempt repairs, electrical or mechanical. Seek qualified repair personnel when servicing. If
you live in the USA, contact Cybex Customer Service at 800-766-3211. If you live outside the USA,
contact Cybex Customer Service at 508-533-4300.
• Disconnect all power before servicing the unit.
• Keep a repair log of all maintenance activities.
• Use only Cybex supplied components to maintain/repair the equipment.
• Do not use attachments unless recommended for the unit by Cybex.
• Do not operate the unit if: (1) the cord is damaged; (2) the unit is not working properly or (3) if the
unit has been dropped or damaged. Seek service from a qualified technician.
• Do not operate electrically powered units in damp or wet locations.
• Do not operate the unit around or where aerosol (spray) or where oxygen products are being used.
• Do not use the unit outdoors.
NOTE: It is the sole responsibility of the user/owner or facility operator to ensure that regular
maintenance is performed.
Cybex Arc Trainer 610A Owner’s Manual
To Next Page
Loading...
Need help?
General
