EasyManua.ls Logo

CYBEX Arc Trainer 610A Service Manual

CYBEX Arc Trainer 610A
42 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Service
Page 4-1
4 - Service
Warnings/Cautions
Cybex Arc Trainer 610A Service Manual
All warnings and cautions listed in this chapter are as follows:
! WARNING: All maintenance activities shall be performed by qualified personnel.
Failure to do so could result in serious injury.
! WARNING: Disconnect the power cord before beginning this procedure. Keep wet items
away from inside parts of the unit. Electrical shock could occur even if the unit is
unplugged.
! WARNING: Flywheel may be hot. Wait until it cools before servicing.
! CAUTION: Do not pinch your fingers between the belt and pulley during this procedure.
! WARNING: Failure to release the drive belt tension may cause personal injury and may
damage the unit.
! WARNING: Do not touch components on the lower board. A charge can remain after
unplugging the power cord and turning off the unit.
! CAUTION: Pulley on eddy current brake is sharp. Wear work gloves to protect your hands.

Other manuals for CYBEX Arc Trainer 610A

Question and Answer IconNeed help?

Do you have a question about the CYBEX Arc Trainer 610A and is the answer not in the manual?

CYBEX Arc Trainer 610A Specifications

General IconGeneral
BrandCYBEX
ModelArc Trainer 610A
CategoryElliptical Trainer
LanguageEnglish

Summary

Service Warnings and Cautions

Test Mode Operation

Stuck Key List and Troubleshooting

Test Mode LED Functions

Test Mode Key Functions

Console Error Code Reference

Speed Sensor Adjustment Procedure

Drive Belt Replacement Guide

Eddy Current Brake Service

Elevation Motor Service

Power Switch Replacement

Pillow Block Service

Upper Pillow Block Service

Procedure for removing and replacing the upper pillow blocks.

Lower Pillow Block Service

Procedure for removing and replacing the lower pillow blocks.

Arm and Handle Link Service

Pedal Arm and Foot Plates

Procedure for removing and replacing pedal arms and foot plates.

Lower Control Board Service

Lower Control Board Fuses

Instructions for locating and replacing fuses on the lower control board.

Upper Display Board Service

Display Cable Service

Upper Display Cable Replacement

Procedure for removing and attaching the upper display cable.

Lower Display Cable Replacement

Procedure for removing and attaching the lower display cable.

Display Overlay Replacement

Related product manuals