CYBEX Arc Trainer 610A Service Manual

Cybex Arc Trainer 610A Service Manual
Service
Page 4-31
Lower Control Board
Tools Required
• Phillips head screwdriver
• 3/8” Nutdriver or socket wrench
• ESD (Electro Static Discharge) grounding strap
! WARNING: Disconnect the power cord before beginning this procedure. Keep wet items away
from inside parts of the unit. Electrical shock could occur even if the unit is
unplugged.
1. Disconnect the external power source.
A. Turn the main power switch above the power inlet to the off (O) position.
B. Unplug the power cord from the power outlet.
2. Remove the access cover.
A. Using a Phillips head screwdriver, remove the four screws securing the access cover.
See Figure 2.
B. Remove the access cover.
Figure 25
Foot Plate
Small Cap (2)
Threadlocker
SHCS (2)
Front Pedal
Arm
Rear Pedal
Arm
Foot
Plate
Shafts

CYBEX Arc Trainer 610A Specifications

General

Brand	CYBEX
Model	Arc Trainer 610A
Category	Elliptical Trainer
Language	English