CYBEX Arc Trainer 610A - Page 44

Cybex Arc Trainer 610A Owner’s Manual
Preventive
Maintenance
Page 4-4
3. Remove the access cover.
A. Using a Phillips screwdriver, remove the two
lower screws securing the access cover.
B. Remove the two upper screws securing the
access cover. See Figure 2.
C. Remove the access cover.
! WARNING: The flywheel may be hot. Wait until it
cools before servicing.
4. Check the condition of each belt.
A. Roll each belt by pulling down on it. Examine the
condition of each belt. If a belt has cracks or
appears worn, it must be replaced immediately
by a qualified service technician.
5. Attach the access cover.
A. Using a Phillips head screwdriver, tighten the
two upper screws first (removed in step 3B).
NOTE: Do not over tighten screws.
B. Tighten the two lower screws, removed in step
3A. NOTE: Do not over tighten screws. See
Figure 2.
6. Test unit for proper operation.
Figure 2
Screw (4)
Access
Cover