Cycle Torch SHARK 500 - Bolt Tail Light

SHARK 500 USER MANUAL
7
Switching lighting modes
OPERATION MODES
The initial two short presses (or single press for
earlier models) of the power button will turn on
the light on High mode. Each additional short
press of the button switches the light from one
mode to the next, in the following order:
1
High
2
Slow ashing
3
Quick ashing
4
Pulse
5
O
TURNING OFF
Press & Hold of the power button will
shut down the Tail Bolt.
RUNNING TIME:
5 – 20 hours, depending on the use mode.
LOW BATTERY LEVEL
The Tail Bolt will automatically turn o when the
battery level is too low. This system protects the
battery from damage, but since it draws a small
amount of current, it can drain the battery beyond
the minimum voltage of the battery. That’s why
it’s not recommended to turn ON the lights after
the programmed shutdown.
Do not wait unl the Tail Bolt goes completely out as this will greatly reduce
the number of charge cycles that the baery can be used and can render the
baery unusable. It is highly recommended to recharge periodically the Tail Bolt.
Charge your bike light every 2-3 months when stored or not in use to prevent baery
degradaon.
Operating modes: High
Slow
ashing
Quick
ashing
Pulse
Run time (in hours) 5 15-20 10-15 10-15
Power (in lumens) 10 10 10 10
BOLT TAIL LIGHT
5
Operation/
Power button