5
1.3: Attaching your Bike to the Trainer
The CycleOps PowerBeam
TM
Pro
trainer is designed
to be used with the provided skewer. Replace the
skewer on the rear wheel of your bike with the one
provided. Make sure the quick release handle is on
the left side of the bicycle and faces upward.
Rotate the yellow skewer clamp knob clockwise to
allow suffi cient clearance for your skewer.
Pull the yellow cam lever down and rotate 90 de-
grees clockwise to unlatch the resistance unit. Pivot
the resistance unit down to allow clearance for your
rear wheel.
CAUTION: In this position the resistance unit can
move freely, keep fi ngers clear of moving parts.
Latch the resistance unit in a down position by rotat-
ing the cam lever 90 degrees counter clockwise and
push the cam lever against the resistance unit.
To Next Page
Loading...
Need help?
General
