EN-6 EN-7
Safety instructionsIntended use
The cyclotest mySense is a medical digital thermometer (direct mode) for
the self-measurement of human basal body temperature.
The device transmits the measured values to the cyclotest mySense app
via a Bluetooth 4.0 interface.
The device is intended exclusively for use with the cyclotest mySense app.
The device cannot be operated without the cyclotest mySense app or with
other apps.
• The device must be used solely for the purpose described in these op-
erating instructions. The manufacturer shall not be held liable for any
damages resulting from improper use.
• Protect the device from dirt, dust and strong sunlight and keep the de-
vice away from excessive heat or cold.
• Using the thermometer in a way that does not comply with the intended
operating conditions can result in inaccurate measurement values.
• Before each measurement, check the integrity of the measuring tip. A
damaged measuring tip can cause injuries.
• Do not bite or bend the sensor. This can cause damage and lead to
malfunctions.
• The use of this device near mobile phones, radios or other strong elec-
tromagnetic elds can cause errors and malfunctions. Maintain a dis-
tance of at least 3.3metres from such devices when using the device.
• The thermometer contains small parts that could be swallowed by chil-
dren. Do not leave the device unattended with children.
• If the device has been stored at temperatures below 10°C or above
40°C, allow it to stand at room temperature for at least 2 hours before
using it.
• If the device is not being used for an extended period of time, remove
the battery.
• Always store the thermometer in the protective cover.
• Do not open the device (except when changing the battery).
• Do not allow the thermometer to fall on the oor. The thermometer is
not shock-resistant or impact-resistant.
To Next Page
Loading...
