Completion of descaling cycle
a.
b.
c.
d.
Turn the knob to the “ ” position,.
The indicator of “ ” turns off.
The indicators of Single-cup (Coffee) button “ ” and Double-cup (Coffee)
button “ ” and “ ” illuminate at the same time.
The buzzer will sound and the indicator of ON/OFF button “ ” will stop flash-
ing and lights solidly, which means the descaling cycle is completed, then the
appliance will go back to the standby mode.
Step 3: Start cleanup
Turn the knob to the “ ” position,
a.
b.
c.
At that time, the indicator of “ ” lights solidly, the indicator of ON/OFF button
“ ” and steam/hot water indicator flashes.
The pump starts to work, the hot water will dispense from the brewing head and
steam tube, and the pump will make different noises after 2 minutes.
When hot water stops coming out from brewing head and steam tube, the descal-
ing is complete.
Ⅸ. Water shortage reminder
When the water tank is short of water, the machine will remind the user to refill the
water tank with water. At this time, the indicators of “ ”, “ ”, “ ”,
“ ”, “ ” and “ ” flash, accompanied with buzzer sound.
Step 2: Prepare to clean up
Important: A maximum of 5 minutes is allowed to take to complete the following
steps before exiting from the descaling cycle.
The steam tube and brewing head need to be cleaned with fresh water for removing
the descaling solution.
Clean the water tank
Fill the water tank with water
Empty the containers
- 24 -
To Next Page
Loading...
Need help?
General