© 2009 Cygnus Automotive Limited
C2468_3 5
2.5 FOR HIRE Mode – For when the taxi is for hire
From ON or OFF, press “Mode" to get into FOR HIRE.
The MR500 may display warning messages in this mode and a
clock or blank display programmed as part of your tariff. At this
stage the Rate Window usually shows the rate to charge but,
according to tariff option, it may show the year to which the tariff
applies. If so, pressing Revert will cancel the year display and
show the charging rate.
Figure 4: For Hire Mode
The charging
rate selected.
The information in this part
of the display depends on
how your MR500 has been
programmed.
Press “SELECT” to choose
the rate to charge. The
MR500 may allow only some
of the available rates to be
selected if your tariff is
“Calendar Controlled”. It may
not allow any manual rate
selection at all.
Press “REVERT”
to turn the MR500
off.
Press “MODE” to
go to HIRED
mode.
To Next Page
Loading...
Need help?
General
