To Next PageTo Next Page
Need help?Do you have a question about the CYmodel P-47 and is the answer not in the manual?
Minimum 6-channel radio, transmitter, receiver, and dry batteries.
Two batteries needed for the remote control transmitter.
Nine servos are required for the model's control surfaces.
100-150cc gas engine and muffler required for the model.
Epoxy glue and instant glue are required for assembly.
Specific fuel required for starting the glow engine.
Silicone tube, fuel pump, and fuel filter for the fuel system.
Equipment to enhance airplane operation and performance.
A propeller matching the engine specifications is required.
Understand the manual before commencing assembly.
Verify all parts are present and undamaged.
Familiarize yourself with the symbols used in the manual.
Mount the aileron and flap components correctly.
Ensure secure gluing of aileron and flap for flight safety.
Install the servo responsible for controlling the aileron.
Install the servo responsible for controlling the flap.
Mount a servo, likely for a control surface.
Mount the elevator control surface onto the aircraft.
Ensure secure gluing of the elevator for flight safety.
Mount the servos that control the elevator movement.
Connect the servos to the elevator control surfaces.
Mount the rudder control surface onto the aircraft.
Ensure secure gluing of the rudder for flight safety.
Mount the servos that control the rudder movement.
Assemble and install the tail wheel mechanism.
Connect the steering mechanism for the tail wheel.
Install servos for rudder control and tail wheel steering.
Mount the main landing gear struts to the fuselage.
Ensure secure attachment of the main landing gear for flight.
Install the retract system for the main landing gear.
Attach the wheels to the main landing gear.
Install servos for the ailerons and flaps into the main wing.
Install the horizontal stabilizer and its servo.
Install the servo controlling the engine's throttle.
Connect main wing, horizontal, and vertical tail sections.
Assemble and connect the fuel tank system.
Mount the 100-150cc gas engine into the fuselage.
Attach the engine cowling to the fuselage.
Install and connect the battery, ignition, and receiver.
Mount the aircraft's canopy.
Adjust aileron and flap travel for flight capabilities.
Adjust elevator travel for optimal flight performance.
Adjust rudder travel for general flight capabilities.
Verify CG position before flight for stability.
General
