CYmodel Spitfire MK IX CY8144B

To Next Page

SAFETY PRECAUTIONS

This radio control model is not a toy!

lFirst-time builders should seek advice from people having building

experience in order to assemble the model correctly and to produce

its performance to full extent.

lAssemble this kit only in places out of childrens reach!

lTake enough safety precautions prior to operating this model.

You are responsible for this models assembly and safe operation!

lAlways keep this instruction manual ready at hand for quick

reference,even after completing the assembly.

lCould cause serious injury or even death

SPECIFICATION

Spitfire MK IX

ALMOST - READY - TO - FLYALMOST - READY - TO - FLY

Before commencing assembly,please read these instructions thoroughly.

Thank you for choosing CYmodel

Global : www.cymodel.com

Australia : www.austars-model.com

Italia : www.biellaexpress.com

Instruction Manual

Item Nr: CY8144B

Wing Span:2350 mm (92.5 in)

Wing Area:91.8 dm (1423sq.in)

Total Length: 2000 mm (78.8 in)

Radio : 6channels , 9 servos

Engine : 50cc gas engine

Main Page

Need help?

Do you have a question about the CYmodel Spitfire MK IX CY8144B and is the answer not in the manual?

Summary

Safety Precautions

Aircraft Specifications

Required for Operation

Radio System Requirements

Details the minimum 6-channel radio and transmitter needed for the aircraft.

Servo and Engine Requirements

Lists the necessity of 9 servos and a 50cc gas engine with muffler.

Servo Installation for Control Surfaces

Install Aileron Servos

Step-by-step guide for installing servos for the ailerons, including linkage.

Main Landing Gear Installation

Install Main Landing Gear (Retracts)

Instructions for connecting the retract system, including warning about sealing.

Rudder and Tail Wheel Assembly

Install Servo of Rudder & Tail Wheel (1)

Detailed steps for installing the servo and linkages for the rudder and tail wheel.

Install Servo of Rudder & Tail Wheel (2)

Further instructions for rudder and tail wheel servo setup, including linkages.

Install Servo of Rudder & Tail Wheel (3)

Final component connections for the rudder and tail wheel servo system.

Engine and Throttle Installation

Installing the Engine (50 cc)

Instructions for mounting the 50cc engine, indicating a 170mm measurement.

Install the Throttle Servo

Control Surface Adjustment

Aileron and Flap Adjustment

Specifies travel values for ailerons and flaps for optimal flight.

Elevator Adjustment

Details the recommended travel limits for the elevator control surface.

Rudder Adjustment

Provides guidance on the correct travel range for the rudder.

Center of Gravity (CG) Adjustment

Instructions for achieving the correct CG by repositioning components.