13
COMMAND DESCRIPTION
MICMODE S/0~3
Mic mode select.
S=Status, 0=O, 1=Normal, 2=Phantom, 3=Line
mode
FADEFAULT Factory default setting.
REBOOT Reboot the unit.
IPCONFIG Print the IP conguration to the screen.
RESETIP Reset the IP conguration to factory defaults.
SHOWMAC Print the MAC address to the screen.
SHOWTPORT Print the Telnet communication port to the screen.
SHOWHPORT Print the HTTP communication port to the screen.
SIPADD Set the IP address.
SNETMASK Set the Net Mask address.
SGATEWAY Set the Gateway address.
SHTTPPORT Set the HTTP communication port (1~62235) [80].
STELNETPPORT Set the Telnet communication port (1~62235) [23].
Note: RS-232 commands will be not executed unless followed by a carriage
return. Commands are case-sensitive.
To Next Page
Loading...
