15
Once in the command line interface (CLI) type "telnet", then the IP address
and hit enter.
Note: The IP address of the Integrated Zone Amplier can be displayed on the
device's OLED monitor by navigating to the IP Cong option in the settings
menu.
This will bring us into the device which we wish to control. Type "H" to list
the available commands.
Type “IPCONFIG” to show all IP congurations. To reset the IP, type
“RESETIP”.
Note: All the commands will be not executed unless followed by a carriage
return. Commands are not case-sensitive. If the IP is changed then the IP
Address required for Telnet access will also change accordingly.
To Next Page
Loading...
