8
5.3 Right Panel
Power Input Optical
Out
IR
1 2 3 4
1
Power: Press to turn on the device or to set it to standby mode. The
blue LED on the top panel will illuminate when the device is powered
and switched on.
2
Input: Select the input port from 1 to 4. The blue LED on the top panel
will illuminate to indicate the selected source.
3
Optical Out: Connect to an amplifier or active speaker with optical
cable for audio output.
4
IR: IR receiver window that receives the IR signal from the supplied
remote control. Please ensure that there is a clear line-of-sight
between the receiver and the remote.
5.4 Rear Panel
DC 5V
1
1
DC 5V: Connect the 5V DC power supply into the unit and plug the
adaptor to an AC wall outlet.
5.5 Remote Control
1
POWER: Press to turn on the devic; press it again
to put the device into standby mode.
2
INPUT 1~4: Press the required input button to
select the input source.
1
2
To Next Page
Loading...
