6.4 Receiver’s Rear Panel
6.3 Transmitter’s Rear Panel
DVI-D
OUT
COAX
OUT
L/R
OUT
CA T5 to DV I 250M / RECEIVER
VIDEO DDC
DC 5V
CAT5 OUTPUT
①
with CAT-5/CAT-5E/CAT-6 cable.
②
DDC CAT 5 INPUT – Connect the DDC input to the DDC output of the
transmitter with CAT-5/CAT-5E/CAT-6 cable.
Note:
For advanced user only, if it's known that the DDC or HDCP data
are required for the source and the display, you can use a single CAT-5
cable for the VIDEO connection only.
③
Power Jack – Connect with 5V / 2.6A power adaptor with power supply.
1 2 3
1 2 3
①
DVI-D OUT – Connect to DVI/HDMI display equipment with DIV or DVI to
HDMI cable.
②
COAX OUT – Connect to audio amplifier or audio equipment
’
s input with
coaxial cable.
Note:
This audio signal is received from CAT 5 with SPDIF format and
therefore, LPCM sound will perform 2CH.
③
L/R OUT – Connect to audio equipment
’
s input with 3.5mm phone jack.
Note:
This audio channel will perform Stereo sound only. When Dolby or
DTS signal is send no sound will be performed.
To Next Page
Loading...
