Cyrus iR14 Remote control User Instrucons
2
REMOTE CONTROL OPERATION
Remote control introducon
The iR14 remote control will send commands to Cyrus
ampliers, CD players, Audio streamers* and the Phono
Signature.
The remote control can also be programmed with the
commands from two other remote control handsets. These
will normally be for your TV and a Satellite or terrestrial TV
set-top box, programmed to the TV and SAT buons, but
could also be other audio components such as a Cyrus tuner
or DVD player etc.
*NOTE: It may be necessary to upgrade the rmware in
an Audio streamer to enable Infra-red remote control
operaon.
Remote control backlight
The remote control keypad includes a back-light. The back-
light will switch on automacally when moved or when a
command is sent.
Fing baeries to the remote control
The baery compartment is on the back of the remote
control.
NOTE: If inputs have been named CD (ampliers and DAC
XP Signature) and/or Stream X (ampliers only), the correct
input will also be selected.
Press the catch on the 1.
baery cover and li o
the cover.
Slide a AAA baery under 2.
the retaining hook in the
upper half of the baery
compartment as shown.
Fit a second AAA baery 3.
into the remaining space.
Replace the baery 4.
cover.
Replace the handset baeries only with AAA baeries of the
same voltage and type.
Discard used baeries in accordance with recycling
regulaons in force in your area.
Press the CYRUS •
key to set the
remote control to
Cyrus mode.