D.A.S. DSP-4080 - Technical Specifications

Specifications
35
Limiters
Program Limiter:
Threshold: +22dBu to -10dBu
Attack time: 0.3 to 90 milliseconds
Release time: 2/4/8/16/32 x Attack time
“D-Max” Limiter:
Attack Time: -60uS
Release Time: Slow/Medium/Fast
Display: 2 x 24 Character LCD
Input meter: 4 x 4 point, -24dB to digital clip
Output meter: 8 x 4 point, -24dB to +4dB into limit
Connectors
Inputs: 3 pin female XLR
Outputs: 3 pin male XLR
External: 9 pin DEE connector (RS232)
RS485: 3 pin male XLR (out) 3 pin male XLR (in)
Power: 3 pin IEC
Due to continuing product improvement the above
specifications are subject to change.
Latency: 1.5mS (analogue in – analogue out @ 96kHz)
Inputs: 4 electronically balanced
Impedance: > 10k ohms.
CMRR : >65dB 50Hz - 10kHz.
MUTE : ON/OFF
Outputs: 8 electronically balanced
Source Imp: < 60 ohms
Min. Load: 600 ohms
Max. Level: +20dBm into 600 ohms
MUTE : ON/OFF
Frequency Resp.: ½dB 20Hz-20kHz ±
Dyn. Range: >116dB 20Hz-20k unweighted
Distortion: < .02%@1kHz,+18dBm
Maximum Delay: 650 mS
Min Step Size: 0.3uS
Input Gain: +6dB to -40dB in 0.1dB steps
Output Gain: +15dB to -40dB in 0.1dB steps
Parametric Equalisation
8 per Input / 9 Sections per Output
Filter Gain: +15dB to -30dB in 0.1dB steps
Freq. Range: 19.7Hz - 32kHz, 1/36 octave steps
Filter Q / BW: 0.4 to 128 / 2.5 to 0.008
(Sections switched to shelving response)
Low frequency: 19.2Hz - 1kHz
High frequency: 1kHz - 32kHz
Shelf gains: ±15dB in 0.1dB steps
High and Lowpass Filters
Filters: 1 of each per output.
Freq. Range HPF: 10Hz - 16kHz
1/36 octave steps.
Freq. Range LPF: 35Hz - 22kHz
1/36 octave steps.
Responses:
st
1 Order 6dB/Oct.
Bessel/Butterworth/Linkwitz-Riley 12-24-48dB/Oct.
Bessel/Butterworth 18dB/Oct.
-3dB @ 32kHz
Power: 60 to 250V ±15% @ 50/60Hz
Consumption: < 30 watts.
Weight:
3.3kg. Net (4.7kg. Shipping)
7.26lb. Net (10.34lb. Shipping)
Size:
44 x 482 x 300 (mm)
1.75"(1U) x 19" x 11.8"
DSP-4080
User’s Manual