Calibration without Distortion Detector DD-1
1. Connect OM-1 as described in installation
section.
2. Play music as loud as possible without
damaging your system or distorting the sound.
3. Carefully, with small adjustment screwdriver,
turn the adjustment pot on the OM-1 fully
counter clockwise. Then turn clockwise until
the display activates the red LED only slightly
on the loudest peaks of the music.
4. Enjoy
Troubleshooting
Problem: The OM-1 doesn’t seem to show any
movement.
Solution: Make sure the Grey signal wire is connected
to audio signal. On most 2 and 4 channel amplifiers the
Grey wire should be connected to the amplifier’s Left
Speaker (+) terminal. For monitoring a (Right) channel
it should be connected to the Right Speaker (-) terminal.
If the right channel doesn’t work try connecting it to the
Right Speaker (+) terminal of amplifier.
To Next Page
Loading...
Need help?
General