6 of 18
We suggest that the ACM units be mounted into each of the side armrests or on the back wood panel of the
seat. Each actuator is supplied with a 51.” motor power cable harness. One (1) 10’ shielded Cat-5 cable is
supplied to connect both ACM together (in daisy chain and One (1) 50’ shielded cat-5 cable is supplied to
connect the ACM unit to the appropriate Motion Controller port (Kinelink port A to D). Below you will find the
dimensions of the 4250i/4400i actuators and the ACM unit.
D-BOX 4250i/4400i actuators dimensions (.75” Bracket)
ACM (Actuator Control Module) dimensions
To Next Page
Loading...
