D Light PRO Ultra - Treatment Execution and Results; Treatment Procedure Steps; HR and SR Mode Procedures

17 - GB GB - 18
ENGLISH ENGLISH
TREATMENT PROCEDURE
1. Clean the area to be treated that you have previously shaved;
2. Cover any moles with a white make-up pencil or a specic product such
as D Light Patch Pro
3. Turn on the device and select the desired treatment using the FUNCTION
button: HR for epilation or SR for photorejuvenation
4. Select the desired operating mode using the MODE button: EXP for
single shot or OPT for slide mode.
5. Select the desired power level from 1 to 3 using the ENERGY button
referring to the phototype table included in this pack and at the end of the
manual.
6. Wear protective goggles.
7. Place the head emitter in touch with the skin and unlock the ash delivery
by quickly pressing the ring button on the handpiece twice.
HR mode (Epilation)
(EXP mode): when the ring button is pressed, 2 consecutive ashes are
released which are used to treat the same area: the r󰀬 weaker pre-heats
the skin to prepare it for the second (more intense) which deactivates the
hair bulb. Once the 2 ashes have nished, go to the next area and press
the shot button again to treat it as done previously.
(OPT mode): hold down the ring button and slide the head over the area
to be treated while the device delivers ashes continuously. Avoid 󰀬acking
more than 2 ashes on the same area.
SR mode (Skin Rejuvenation)
(EXP mode): when the re button is pressed, a ash is emitted which is
used to treat the area, once the ash is over, move to the next area and
press the re button again to treat it. Avoid overlapping more than one
ash on each area to be treated.
(OPT mode): hold down the ring button and slide the head over the area
to be treated while the device delivers ashes continuously, avoid
overlapping more than 2 ashes on the same area to be treated.
8. Clean the treated area after the operation;
9. Apply D Light Po󰀬 treatment cream included in the package and massage
until completely absorbed.
RECOMMENDATIONS
Do not use the pulsed light on moles, tattoos, birthmarks and wherever
the skin has pathologies or lesions of any kind.
When solar radiation is intense, for 7 days following treatment, it is
recommended to apply a sunscreen with almo󰀬 SPF 50 lter on the
treated areas that are exposed to the sun and avoid tanning or sun
lamps.
SIGNS OF TREATMENT EFFECTIVENESS
If after the hair removal treatment the skin is reddened and there is a
sensation of heat, it is a sign that the treatment has been e󰀨ective.
Normally, these sensations disappear within a couple of hours.
FEELING OF DISCOMFORT
There may be a slight discomfort during the treatment which people
compare to the snap of an ela󰀬ic on the skin, this is absolutely normal, if
in󰀬ead of feeling pain, 󰀬op the treatment and lower the potency.