D Light PRO Ultra - Display, Maintenance, and Troubleshooting; Troubleshooting

13 - GB GB - 14
ENGLISH ENGLISH
9) Total Shots Display
Total Shots &
Error Code
Display Area
Each time,after 󰀬arting machine, the total shots & error code will be
displayed;
DISPLAY INTRODUCTION:
The r󰀬 time displays 100,000 and tens of thousands, the second displays
thousands and hundreds, and the third displays tens and singles. Example:
The r󰀬 time the window displays 12, the second time displays 23, and the
third time displays 45, the total count is 122345. When the total count
exceeds 999999 times, the total count is displayed as “--”“--”“--”;
10) Error Code Display
When machine has trouble during operation:
- Start machine and the trouble indicator will ash red with “Di, Di, Di…”
sound;
- Error code will be showed in Total Shots & Error Code display area;
- Machine has no response;
Trouble shooting: Unplug the power cord of the host machine and
contact the manufacturer or authorized service center.
11) Turn o󰀨 Machine
- Manner 1: After operation, press
to turn o󰀨 machine; Power-on & Trouble
Indicator will be o󰀨;
- Manner 2: If no operation,machine will be o󰀨 in one minute automatically;
DAILY MAINTENANCE
After each use, shut down and unplug the power cord of the host. After
5 minutes of natural placement, wipe the light outlet and cooling area of
the handle with wet paper towels. After wiping, the handle is returned to
the handle groove of the host.
TROUBLESHOOTING
Trouble Take Measure
It’s impossible
to start machine;
1. Pull and plug power cord again;
2. Please contact the after-sales service;
Unlock indicator of
handle is not on;
1.Check whether the handle trigger was
pressed twice in quick succession;
2. Please contact the after-sales service;
Unmentioned in this manual, unauthorized
maintenance and modication of this
machine may put the operator in danger
of voltage. Improper use or adjustment
of the system invalidates the warranty
agreement.