D-Link AirPlus G DWL-G700AP - DHCP Configuration

15
Using the Conguration Utility (continued)
Home > DHCP
DHCP Server: Select Enabled or Disabled. Disabled is the default setting.
If you want to use the DWL-G700AP as a DHCP server, to automatically assign
dynamic IP addresses on the network, you will select Enabled.
Starting IP Address: If you have enabled the DHCP server function, enter the
starting point of the IP address range for your network.
Ending IP Address: Enter the ending IP address of your IP address range, if you
have enabled the DHCP function of the DWL-G700AP.
Lease Time: Choose the length of time during which the DHCP function of the
DWL-G700AP automatically regenerates the IP addresses to the devices in your
network.
DHCP Client Table: Lists the devices on your network that are receiving dynamic
IP addresses from the DWL-G700AP.