48
Device
Configuration>Wireless
• SSID: The Service Set (network)
Identifier of your wireless network.
• Channel: Allows you to select a
channel. 6 is the default setting.
• SSID Broadcast: Allows you to
enable or disable the broadcasting
of the SSID to network clients.
• Super G: Super G is a group of
performance enhancement features
that increase end user application
throughput in an 802.11g network.
Super G is backwards compatible
with standard 802.11g devices.
For ideal performance, all wireless
devices on the network should be
Super G capable. The modes are
listed below:
• Radio Wave: Enable or disable the wireless functionality of the selected device(s).
• Data Rate: A pulldown menu to select the maximum wireless signal rate for the
selected devices(s).
• Beacon Interval (20~1000): Beacons are packets sent by an access point to
synchronize a network. Specify the beacon value for the selected device(s) here.
The default value of 100 is recommended.
• DTIM (1~255): DTIM (Delivery Traffic Indication Message) is a countdown informing
clients of the next listening window for broadcast and multicast messages.
• Fragment Length (256~2346): This sets the fragmentation threshold (specified
in bytes). Packets exceeding the value set here will be fragmented. The default is
2346.
• RTS Length (256~2346): The RTS value should not be changed unless you encounter
inconsistent data flow. The default value is 2346.
• Tx Power: A pulldown menu for selecting the transmit power of the selected
device(s).
Using the AP Manager (continued)
• Auto Channel Scan: Enable to scan for the least populated channel.
To Next Page
Loading...
