D-Link COVR-C1202 User Manual

46D-Link COVR-C1202 User Manual
Section 3 - Conguration
DHCP Server
Status: Enable or disable the DHCP server.
DHCP IP Address
Range:
Enter the starting and ending IP addresses for the DHCP server’s IP
assignment.
Note: If you have reserved static IP addresses to client devices, make
sure the IP addresses are outside of this range or you might have an IP
conflict. Refer to Connected Clients section 14 for how reserve IP
addresses for clients.
DHCP Lease Time: Enter the length of time for the IP address lease (in minutes).
Always Broadcast: Enable this feature to broadcast your network's DHCP server to LAN/
WLAN clients.
Advanced Settings
WAN Port Speed: You may set the port speed of the Internet port to 10 Mbps, 100
Mbps, 1000 Mbps, or Auto (recommended).
UPnP: Enable or disable Universal Plug and Play (UPnP). UPnP provides
compatibility with networking equipment, software, and peripherals.
IPv4 Multicast
Streams:
Enable to allow IPv4 multicast trac to pass through Covr Point A
from the Internet.
IPv6 Multicast
Streams:
Enable to allow IPv6 multicast trac to pass through Covr Point A
from the Internet.
Click Save when you are done.
Network (Continued)

D-Link COVR-C1202 Specifications

General

Brand	D-Link
Model	COVR-C1202
Category	Network Router
Language	English