What to do if WPS setup is not working on my D-Link Extender?
If WPS setup isn't working for your D-Link Extender, it might be because WPS is disabled on your router or modem. If the WPS Status LED on your router or modem doesn't blink when you press the WPS button, try holding the button a bit longer. If it still doesn't blink, configure your Range Extender using the QRS Mobile Setup method.
Why does my D-Link Extender wireless connection keep dropping?
If your D-Link Extender's wireless connection drops, make sure the DAP-1325 is within range of your wireless router. Try moving it closer to the router and check that the Status LED is solid green. Also, when repeating a wireless signal, devices connected to the extender might experience reduced speed compared to connecting directly to the router.
What to do if I forgot my D-Link DAP-1325/E Extender password?
If you've forgotten your D-Link DAP-1325 password, or want to reset it to the factory default settings: 1. Press and hold the reset button on the bottom of the extender using a paper clip. 2. Release the button after a minimum of 10 seconds; the Status light will turn red. You may also repeat the WPS process, following the steps to connect to your router using WPS.
General| Device Type | Wireless Range Extender |
|---|---|
| Product Type | Range Extender |
| Frequency Band | 2.4 GHz |
| Maximum Wireless Speed | 300 Mbps |
| Maximum Data Rate | 300 Mbps |
| Security | WPA/WPA2 |
| Antenna Gain | 2 dBi |
| Humidity | 10% to 90% non-condensing |
| Certifications | CE, FCC, IC |
| Wireless Standard | 802.11n/g/b |
| Ports | 1 x 10/100 Mbps Ethernet |
| Power Supply | AC 100-240V, 50/60Hz |
| Antenna Type | External |
| Button | WPS Button, Reset Button |
| Operating Temperature | 0 to 40 °C |
| Storage Temperature | -20 to 65 °C |
To Next Page
