EasyManuals Logo

D-Link DAP-1950 Quick Installation Guide

D-Link DAP-1950
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
INSTALLATION
DAP-1950 || AC1900 High-Performance Mesh
Wi-Fi Range Extender
Quick Installation Guide
Quick Installation Card
ENGLISH
PACKAGE CONTENTS
OPTION 1
DLINK WIFI APP SETUP QUICK WPS SETUP
OPTION 2
Quick Installation Guide
DAP-1950
AC1900 High-Performance Mesh Wi-Fi Range Extender
Download the D-Link Wi-Fi app and launch it.
1 /
Tap Install New Device. Scan the QR code on the Quick
Installation Card. Follow the on-screen instructions to complete
the setup.
2 /
D-Link Wi-Fi
D-Link Wi-Fi
Plug your Range Extender into an available outlet near your wireless
router and wait until the Status LED is blinking amber (this may take
up to 3 minutes). You can move it to a more suitable location after it
is set up. If the status LED does not light up, ensure the power toggle
switch underneath is in the on position.
1 /
Press the WPS (Wi-Fi Protected Setup) button on your wireless
router for 3 seconds. An LED should start blinking on your router. If
it does not blink, see the important note below.
2 /
Once confirmed that the WPS light is
blinking on your router, within one minute,
press the WPS button on your Range
Extender for 2-3 seconds. The Status LED
should start to blink green.
3 /
When the Status LED turns solid green (may take up to 3 minutes),
this indicates that your Range Extender is securely connected to
your wireless router.
4 /
Your setup is complete! You can now unplug and move your Range Extender to
a location between your Wireless Router and the area where you want wireless
coverage. By default, your Range Extender will share the same Wi-Fi name and
password as your Router.
If after moving your Range Extender, the signal strength indicator is showing one
single amber bar or if your Range Extender LED does not turn solid green within 3
minutes, move your Range Extender to a wall outlet closer to your wireless router.
IMPORTANT
WPS may be disabled on some Routers or Modems. If the WPS Status LED on your Router or
Modem does not start blinking when you have pressed the WPS button, try again and hold
it a little longer. If it still does not blink, STOP, and congure your Range Extender using
Option 1: D-Link Wi-Fi App Setup.
WPS
Button
Model Name: DEVICE
Wi-Fi Name: dlink-XXXX
Password: XXXXXXXX
S/N: 123456789
SETUP QR CODE

Other manuals for D-Link DAP-1950

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the D-Link DAP-1950 and is the answer not in the manual?

D-Link DAP-1950 Specifications

General IconGeneral
BrandD-Link
ModelDAP-1950
CategoryExtender
LanguageEnglish

Related product manuals