Installation
Rotate the top cover counter-clockwise
and lift it up.
Using the provided Ethernet cable connect
one end to your camera and the other-end
to your router or switch.
Connect the external power supply to
the power receptor and to plug into a
wall outlet.
Ensure the cables are seated in the
cable channel.
Set the cover in place and rotate to align the
cable channel guide over the cable channel.
It is recommended to complete the Setup
Wizard before putting the cover back
on. Skip to page 5 if you have a D-Link
Cloud router or page 6 if you don’t. Once
completed, you can refer to this step to put
the cover back on.
1
2
Note: If you want to use a wireless connection,
you still need to connect the Ethernet cable
during setup unless you use WPS.
3
4
5
4
ENGLISH
To Next Page
Loading...
