D-Link DCS-6010L

If you have a D-Link Cloud Router with an Internet connection, you can take
advantage of Zero Conguration. This feature automatically congures your
camera’s settings for you and adds it to your mydlink account automatically.
If you do not have a D-Link Cloud router, refer to the next page to install and
congure your camera.
If you wish to connect your camera to your router wirelessly, you can simply disconnect
the Ethernet cable and move the camera to its intended location after you have added
the camera to your account (step 3).
Zero Conguration Setup
1
2
From any computer, open a web browser, go
to http://www.mydlink.com and log into
your account.
Click on the device name when the notice
appears to add the camera to your account.
3
Connect the other end of the Ethernet cable to your
D-Link Cloud Router and connect the camera’s power
adapter to a power outlet.
Connect the Ethernet cable and power adapter to the
camera. Refer to the previous page on how to connect
an Ethernet cable.
Note: You can use WPS instead of using an Ethernet
cable. Simply press the WPS button on the camera and
then within two minutes press the WPS button on your
Cloud Router. Skip to step 3.
DCS-6010L
5
ENGLISH