5
You must change the Admin ID and
Password immediately to protect
your camera against unauthorized
access. By default, the Admin ID and
Password are blank. To change the
Admin ID and Password, select both
Change boxes and enter a New ID
and New Password.
Enter an IP Address and Subnet
Mask for your camera. Enter your
Gateway and DNS settings. These
settings must correspond with your
network settings for you to access
the camera. If you are unsure of what
these settings should be, check with
your network administrator.
Running the Setup Wizard (continued)
Click Next
Click Next
Click Wizard to begin
Your camera’s IP Address will be
displayed here if it is valid.
To run the Setup Wizard, click on
Start->Programs->DCS-900 Series
SetupWizard.
To Next Page
Loading...
Need help?
General
