2
Quick Installation Guide
DCS-910
10/100 Fast Ethernet Internet Camera
DCS-920
Wireless G Internet Camera
Package Contents
If any of the items are missing, please contact your retailer.
DCS-910 or
920 Internet
camera
CD-ROM
with
manual
and
software
Category 5
Ethernet cable
Power
adapter
Camera
stand
Wireless
antenna
(DCS-920
only)
Hardware Installation
Connect the Wireless Antenna (DCS-920 only)
Screw the Wireless antenna onto the Internet camera’s antenna
connector.
Connect the Ethernet Cable
Connect the Ethernet cable to the Internet camera’s Ethernet port
and attach the other end of the cable to the network.
Note:
This step is necessary to configure DCS-920.
Attach the Power Adapter
Attach the power adapter to the Internet camera’s power socket and
connect it to a power outlet.
The camera’s LED will light red when it receives power.
The LED will light green after the camera connects to the network.
The LED will flash green while accessing the camera.
Please refer to the Manual on the CD to install the software utility
and finish installation.
To Next Page
Loading...
Need help?
General
