9 D-Link DCS-910/920 Quick Install Guide
Configuration
Configuring Your Camera with
the Installation Wizard
Click on the D-Link Setup Wizard SE icon that was created in your
Windows Start menu.
The Setup Wizard will appear and show the MAC address of the
DCS-910/920 and an IP Address (which may or may not be correct
depending on what you have your DCS-910/920 connected to). If
you have a DHCP server on your network, there will be a valid IP
Address displayed here.
Note: A DHCP server is a device that supplies IP addresses to your
network devices automatically.
Click the Wizard button
Your camera’s IP Address will
be displayed here along with its
corresponding MAC Address.
To Next Page
Loading...
