D-Link DGS-1100-24P - Spanning Tree Protocol (STP)

D-Link DGS-1100 Series Switch User Manual
Click the Back button to return to the previous window.
When Hybrid was selected as the VLAN Mode, the following page will appear.
Figure 7-13 Configure VLAN Interface - Hybrid window
The fields that can be configured are described below:
Parameter Description
VLAN Mode
Select the VLAN mode option here. Options to choose from
are Access, Hybrid, and Trunk.
Acceptable Frame
Select the acceptable frame behavior option here. Options to
choose from are Tagged Only, Untagged Only, and Admit
All.
Ingress Checking
Select the check box to enable or disable the ingress
checking function.
VID
Enter the VLAN ID used for this configuration here. This
value must be between 1 and 4094.
Action
Select the action that will be taken here. Options to choose
from are Remove, Tagged, and Untagged.
Allowed VLAN Range
Enter the allowed VLAN range information here.
Click the Apply button to accept the changes made.
Click the Back button to return to the previous window.
When Trunk is selected as the VLAN Mode, the following page will appear.
Figure 7-14 Configure VLAN Interface - Trunk window
The fields that can be configured are described below:
4
4
2
2