Need help?Do you have a question about the D-Link DGS-1100-26MP and is the answer not in the manual?
General| Ports | 26 |
|---|---|
| PoE Ports | 24 |
| Total PoE Budget | 370W |
| Switching Capacity | 52 Gbps |
| Forwarding Rate | 38.69 Mpps |
| Layer | Layer 2 |
| MAC Address Table Size | 16K |
| PoE Standards | IEEE 802.3af/at |
| VLAN Support | Yes |
| Quality of Service (QoS) | Yes |
| Power Supply | Internal |
| Jumbo Frame | 9K |
| Management | SNMP |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -40°C to 70°C |
| Humidity | 10% to 90% (non-condensing) |
Instructions for desktop, shelf, and rack installation methods.
Steps for connecting the AC power cord and proper grounding.
Step-by-step guide to connect and log into the switch's web interface.
Guides through basic configuration settings and mode selection.
Diagram showing connected devices, their status, and topology.
Information on switch system, PoE, and bandwidth utilization.
Overview of PoE usage, power budgets, and port status.
Procedures for upgrading, backing up, and managing switch firmware.
Methods for saving and loading switch configuration settings.
Instructions for performing factory resets and system reboots.
To Next Page
